Art and Architecture Building, Room 2115
2000 Bonisteel Boulevard Ann Arbor, MI 48109
The media center will close for the holidays at 3pm on 12/23. It will remain closed until 8am on 1/03.
For the week of January 3 - 6, the media center will be open from 8am to 5pm.
The media center will then return to regular hours of 8am - 7pm
The Media Center accepts credit cards, cash, checks, and we will resume accepting Blue Bucks with the Fall 16 semester.
Please optimize / rasterize your documents before bringing them to the Media Center to print.
- Optimize or Rasterize (PDF)
- Copyright Clearance (PDF)
- Plot Ticket (PDF)
- Job Ticket for Faculty Use / Shortcode Billing (PDF)
- Scan Ticket (PDF)
- Self Service Plotting Tips (PDF)
Seven steps to hassle-free printing
1. Is it necessary?
Do you really need to print long text documents off the web or coursetools or can you find them again online when you need them? Do you need to print each revision stage of a model or document? To get especially large images on the wall, does it make sense to use a projector instead?
2. Know your device options
Choose the right printer for the job. Think about availability, cost, paper size and type, etc. Configure your machine with more than one printing option.
3. File formats and conversions
RGB or CMYK? PSD, JPG, or TIF? See the helpdesk's table of common file conversions.
4. Think about file size
Print files can be huge, and huge files can slow things down. Do you really need 3000 x 4000 pixels? Are you aware that printing a grayscale image as an RGB file takes four times as long? Understand file compression in JPEG and don't be afraid to use it.
Think carefully about what you can and cannot (or should not) put through printing devices. Use standard sheet sizes whenever you can. Don't waste (and pay for) expensive rolls of plotter paper.
This is the most essential advice: preview, preview, preview. Where appropriate, run a test print on a nearby laser printer. Check printable area, cropping, orientation, font substitution, appearance of linked items, grayscale versus color, etc.
7. Leave time
Plan ahead for some delay. Better yet, plan to print when demand is lower. Some schools require 24 hours notice on large color prints. We do not. And some places charge three times as much. We have a good deal here. Please work under its terms.
The Makerbot Replicator 2X is a 3D printer that uses ABS plastic to build models up to 9.8"(length) x 6.3"(width) x 5.9"(height) in up to two colors. The Media Center is offering Makerbot fabrication on a drop-off basis when provided a model that has both the Rhino and .stl versions. Status can be checked on the schedule and then picked up once the job has completed. Questions, comments, or concerns can be sent to email@example.com.